¶ Install
¶ 🔩 Totem installation
The totem is shipped in a protective case. You can assemble it yourself by following the procedure below:
- Open the box from the top, and remove the protective covers:
 |
 |
- Remove the stand and accessories from the sides of the carton.
 |
 |
| ------ | ------ |
 |
 |
- Unpack the 6 nuts/washers and screw them into the holes in the base. When all 6 nuts and washers are all tightly screwed in, you can raise the totem.
 |
 |
¶ 🔩 Installation du Player
-
Connect the multi-socket to an outlet, connect the totem to one port on the multi-socket, and the player power supply to another.
- For the player, you can plug it into the rear of the Totem on the HDMI port.
- For the connectivity part, you need internet:
-
For better player integration, you can install the multi-socket in the bottom of the totem, then plug in the player's power supply and the totem's power cord, so that only the multi-socket's cord comes out. There's a notch to let the power cord out of the totem.
¶ Configuration
- Remove the wear protection tab from the remote control battery.
- Switch on the totem. On the back of the totem is a socket and a switch.
- To use the remote control, position it close to the infrared receiver on the bottom right of the screen.
Reduce the volume to 1, if you don't want to use any sound.
- On the remote control, press B, and select HDMI.
- Press Menu on the remote, go to Display Setup, Aspect Ratio, and select PointTopoint.
Optional: If your display is slightly cut and offset from the screen, follow this short procedure.
¶ How to reset your screen resolution to 1920x1080
- Press the MENU key
- Press the 2-5-8-0 buttons
- Press 1-9-2-0, the resolution changes to 1920x1080. Restart the screen and check that the resolution has changed to 1920x1080.